R3303-HP HSR6800 Routers MPLS Command Reference

148
Parameters
timer-interval: Value of the failed link timer, in the range of 0 to 300 seconds. The default is 10 seconds.
Usage guidelines
The failed link timer starts once a link goes down. If the IGP removes or modifies the link before the timer
expires, CSPF updates information about the link in TEDB and stops the timer. If the IGP does not remove
or modify the link before the timer expires, the state of the link in TEDB will change to up.
Examples
# Set the failed link timer to 50 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te cspf timer failed-link 50
Related commands
mpls te cspf
mpls te ds-te ietf bc-mode
Use mpls te ds-te ietf bc-mode to specify the bandwidth constraints model in IETF DS-TE mode.
Use undo mpls te ds-te ietf bc-mode to restore the default.
Syntax
mpls te ds-te ietf bc-mode mam
undo mpls te ds-te ietf bc-mode
Default
The bandwidth constraints model in IETF DS-TE mode is RDM.
Views
MPLS view
Default command level
2: System Level
Parameters
mam: Specifies the bandwidth constraints model as MAM.
Usage guidelines
This command is only applicable to the IETF DS-TE mode. In prestandard DS-TE mode, the bandwidth
constraints model can only be RDM.
After you change the bandwidth constraints model in IETF DS-TE mode, all CR-LSPs with non-zero
reserved bandwidths will be cleared on the device.
Examples
# Configure the BC model in IETF mode as MAM.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te ds-te ietf bc-mode mam