R3303-HP HSR6800 Routers MPLS Configuration Guide

103
[RouterA-Tunnel1] ip address 7.1.1.1 255.255.255.0
[RouterA-Tunnel1] tunnel-protocol mpls te
[RouterA-Tunnel1] destination 4.4.4.9
[RouterA-Tunnel1] mpls te tunnel-id 10
[RouterA-Tunnel1] mpls te signal-protocol rsvp-te
[RouterA-Tunnel1] mpls te bandwidth 2000
[RouterA-Tunnel1] mpls te path explicit-path atod preference 5
[RouterA-Tunnel1] mpls te commit
[RouterA-Tunnel1] quit
9. Verify the configuration:
Execute the display interface tunnel command on Router A. The output shows that the tunnel
interface is up.
[RouterA] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 64000
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set.
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
Execute the display mpls te tunnel-interface command on Router A to view detailed information
about the MPLS TE tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name : Tunnel1
Tunnel Desc : Tunnel1 Interface
Tunnel State Desc : CR-LSP is Up
Tunnel Attributes :
LSP ID : 1.1.1.9:2
Session ID : 10
Admin State : UP Oper State : UP
Ingress LSR ID : 1.1.1.9 Egress LSR ID: 4.4.4.9
Signaling Prot : RSVP Resv Style : SE
Class Type : CT0 Tunnel BW : 2000 kbps
Reserved BW : 2000 kbps
Setup Priority : 7 Hold Priority: 7
Affinity Prop/Mask : 0x0/0x0