R3303-HP HSR6800 Routers MPLS Configuration Guide

106
[RouterB-mpls] mpls rsvp-te hello
[RouterB-mpls] interface giabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mpls
[RouterB-GigabitEthernet2/1/1] mpls te
[RouterB-GigabitEthernet2/1/1] mpls rsvp-te
[RouterB-GigabitEthernet2/1/1] mpls rsvp-te hello
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface giabitethernet 2/1/2
[RouterB-GigabitEthernet2/1/2] mpls
[RouterB-GigabitEthernet2/1/2] mpls te
[RouterB-GigabitEthernet2/1/2] mpls rsvp-te
[RouterB-GigabitEthernet2/1/2] mpls rsvp-te hello
[RouterB-GigabitEthernet2/1/2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] mpls lsr-id 3.3.3.9
[RouterC] mpls
[RouterC-mpls] mpls te
[RouterC-mpls] mpls rsvp-te
[RouterC-mpls] mpls rsvp-te hello
[RouterC-mpls] interface giabitethernet 2/1/1
[RouterC-GigabitEthernet2/1/1] mpls
[RouterC-GigabitEthernet2/1/1] mpls te
[RouterC-GigabitEthernet2/1/1] mpls rsvp-te
[RouterC-GigabitEthernet2/1/1] mpls rsvp-te hello
[RouterC-GigabitEthernet2/1/1] quit
4. Configure IS-IS TE. (Details not shown.)
5. Configure the MPLS TE tunnel. (Details not shown.)
6. Configure RSVP-TE GR:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls
[RouterA-mpls] mpls rsvp-te graceful-restart
# Configure Router B.
<RouterB> system-view
[RouterB] mpls
[RouterB-mpls] mpls rsvp-te graceful-restart
# Configure Router C.
<RouterC> system-view
[RouterC] mpls
[RouterC-mpls] mpls rsvp-te graceful-restart
7. Verify the configuration:
# After the configuration, a tunnel is created between Router A and Router C. Execute the following
command. You can see that the neighbor's GR status is Ready.
<RouterA> display mpls rsvp-te peer
Interface GigabitEthernet2/1/1