R3303-HP HSR6800 Routers MPLS Configuration Guide

107
Neighbor Addr: 10.1.1.2
SrcInstance: 880 NbrSrcInstance: 5017
PSB Count: 0 RSB Count: 1
Hello Type Sent: REQ Neighbor Hello Extension: ENABLE
SRefresh Enable: NO
Graceful Restart State: Ready
Restart Time: 120 Sec Recovery Time: 300 Sec
MPLS RSVP-TE and BFD cooperation configuration example
Network requirements
Run OSPF on Router A and Router B to ensure IP connectivity.
Enable MPLS RSVP-TE BFD on the interfaces connecting the two routers. If the physical link between
Router A and Router B fails, BFD can detect the failure quickly and inform MPLS RSVP-TE of the failure.
Figure 28 Network diagram
Configuration procedure
1. Configure MPLS RSVP-TE basic settings:
# Configure Router A.
<RouterA> system-view
[RouterA] mpls lsr-id 1.1.1.1
[RouterA] mpls
[RouterA-mpls] mpls te
[RouterA-mpls] mpls rsvp-te
[RouterA-mpls] quit
[RouterA] interface giabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mpls
[RouterA-GigabitEthernet2/1/1] mpls te
[RouterA-GigabitEthernet2/1/1] mpls rsvp-te
[RouterA-GigabitEthernet2/1/1] mpls rsvp-te bfd enable
[RouterA-GigabitEthernet2/1/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] mpls lsr-id 2.2.2.2
[RouterB] mpls
[RouterB-mpls] mpls te
[RouterB-mpls] mpls rsvp-te
[RouterB-mpls] quit
[RouterB] interface giabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mpls