R3303-HP HSR6800 Routers MPLS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP HSR6804 Router Chassis

111

112

113

114

115

116

117

118

119

120

108

[RouterB-GigabitEthernet2/1/1] mpls te

[RouterB-GigabitEthernet2/1/1] mpls rsvp-te

[RouterB-GigabitEthernet2/1/1] mpls rsvp-te bfd enable

[RouterB-GigabitEthernet2/1/1] quit

2. Configure OSPF:

# Configure Router A.

<RouterA> system-view

[RouterA] ospf

[Router-A-ospf-1] area 0

[Router-A-ospf-1-area-0.0.0.0] network 12.12.12.1 0.0.0.255

[Router-A-ospf-1-area-0.0.0.0] network 1.1.1.1 0.0.0.0

[Router-A-ospf-1-area-0.0.0.0] quit

[Router-A-ospf-1] quit

# Configure Router B.

<RouterB>system-view

[RouterB] ospf

[RouterB-ospf-1] area 0

[RouterB-ospf-1-area-0.0.0.0] network 12.12.12.2 0.0.0.255

[RouterB-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0

[RouterB-ospf-1-area-0.0.0.0] quit

[RouterB-ospf-1] quit

3. Configure IP addresses for the interfaces:

# Configure Router A.

[RouterA] interface giabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] ip address 12.12.12.1 24

[RouterA-GigabitEthernet2/1/1] quit

# Configure Router B.

[RouterB] interface giabitethernet 2/1/1

[RouterB-GigabitEthernet2/1/1] ip address 12.12.12.2 24

4. Configure the MPLS TE tunnel:

# Configure an RSVP-TE tunnel between Router A and Router B.

[RouterA] interface tunnel 1

[RouterA-Tunnel1] ip address 10.10.10.1 24

[RouterA-Tunnel1] tunnel-protocol mpls te

[RouterA-Tunnel1] destination 2.2.2.2

[RouterA-Tunnel1] mpls te tunnel-id 10

[RouterA-Tunnel1] mpls te signal-protocol rsvp-te

[RouterA-Tunnel1] mpls te commit

[RouterA-Tunnel1] return

5. Verify the configuration:

# Display detailed information about the BFD session between Router A and Router B.

<RouterA> display bfd session verbose

Total Session Num: 1 Init Mode: Active

Session Working Under Ctrl Mode: