R3303-HP HSR6800 Routers MPLS Configuration Guide

116
Opaque Type : 1
Opaque ID : 0
Advertising Router ID : 1.1.1.9
LSA Age : 1118
Length : 28
LSA Options : E O
LS Seq Number : 8000000B
CheckSum : ECBF
MPLS TE Router ID : 1.1.1.9
8. Create a static route to direct traffic to the MPLS TE tunnel:
[RouterA] ip route-static 30.1.1.2 24 tunnel 2 preference 1
Execute the display ip routing-table command on Router A. You can see a static route entry with
Tunnel2 as the outgoing interface.
CR-LSP backup configuration example
Network requirements
Set up an MPLS TE tunnel from Router A to Router C. Use CR-LSP hot backup for it.
Figure 30 Network diagram
Device Interface IP address Device Interface IP address
Router A Loop0 1.1.1.9/32 Router D Loop0 4.4.4.9/32
GE 2/1/1 10.1.1.1/24 POS 5/1/0 30.1.1.2/24
POS 5/1/1 30.1.1.1/24 POS 5/1/1 40.1.1.1/24
Router B Loop0 2.2.2.9/32 Router C Loop0 3.3.3.9/32
GE 2/1/1 10.1.1.2/24 GE 2/1/1 20.1.1.2/24
GE 2/1/2 20.1.1.1/24 POS 5/1/1 40.1.1.2/24
Configuration procedure
1. Configure IP addresses and masks for the interfaces according to Figure 30. (Details not shown.)
2. Enable IS-IS to advertise host routes with LSR IDs as destinations on each node. (Details not shown.)