R3303-HP HSR6800 Routers MPLS Configuration Guide

135
Max Reservable Bandwidth PreStandard RDM : 0 kbits/sec
Max Reservable Bandwidth IETF RDM : 10000 kbits/sec
Max Reservable Bandwidth IETF MAM : 0 kbits/sec
Downstream LSP Count : 1
UpStream LSP Count : 1
Downstream Bandwidth : 4000 kbits/sec
Upstream Bandwidth : 0 kbits/sec
IPUpdown Link Status : UP
PhysicalUpdown Link Status : UP
BC PreStandard Mode RDM(kbps) IETF Mode RDM(kbps) IETF Mode MAM(kbps)
0 0 10000 0
1 0 8000 0
2 0 5000 0
3 0 2000 0
TE CLASS CLASS TYPE PRIORITY BW RESERVED(kbps) BW AVAILABLE(kbps)
0 0 7 0 6000
1 1 7 0 4000
2 2 7 0 1000
3 3 7 0 1000
4 0 0 0 6000
5 1 0 0 4000
6 2 0 4000 1000
7 3 0 0 1000
8. Create a static route to direct traffic destined for subnet 30.1.1.0/24 into the MPLS TE tunnel:
[RouterA] ip route-static 30.1.1.2 24 tunnel 1 preference 1
Execute the display ip routing-table command on Router A. The routing table has a static route
entry with interface Tunnel 1 as the outgoing interface.
MPLS LDP over MPLS TE configuration example
Network requirements
Router A through Router E all support MPLS and run OSPF as the IGP.
Establish a local LDP session between Router A and Router B, as well as between Router C and Router D.
Establish a remote LDP session between Router B and Router C.
Establish an MPLS TE tunnel along Router B—Router E—Router C by using RSVP-TE.