R3303-HP HSR6800 Routers MPLS Configuration Guide

141
Out-Interface : POS5/1/0
LspIndex : 3073
Tunnel ID : 0x11000c
LsrType : Ingress
Bypass In Use : Not Exists
BypassTunnel : Tunnel Index[---]
----------------------------------------------------------------------
LSP Information: LDP LSP
----------------------------------------------------------------------
No : 2
VrfIndex :
Fec : 3.3.3.3/32
Nexthop : 10.1.1.1
In-Label : NULL
Out-Label : 3
In-Interface : ----------
Out-Interface : Tunnel4
LspIndex : 6147
Tunnel ID : 0x11000e
LsrType : Ingress
Outgoing Tunnel ID : 0x15000d
Label Operation : PUSH
No : 3
VrfIndex :
Fec : 3.3.3.3/32
Nexthop : 10.1.1.1
In-Label : 1024
Out-Label : 3
In-Interface : ----------
Out-Interface : Tunnel4
LspIndex : 6148
Tunnel ID : 0x11000f
LsrType : Transit
Outgoing Tunnel ID : 0x15000d
Label Operation : SWAP
MPLS TE in MPLS L3VPN configuration example
Network requirements
CE 1 and CE 2 belong to VPN 1. They are connected to the MPLS backbone respectively through PE 1
and PE 2. The IGP protocol running on the MPLS backbone is OSPF.
• Set up an MPLS TE tunnel to forward traffic of VPN 1 from PE 1 to PE 2.
• To allow the MPLS L3VPN traffic to travel the TE tunnel, configure a tunneling policy to use a CR-LSP
as the VPN tunnel when creating the VPN.