R3303-HP HSR6800 Routers MPLS Configuration Guide

143
display ip routing-table command. You can see that the PEs have learned the routes to the
loopback interfaces of each other. Take PE 1 for example:
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 2.2.2.2
Neighbors
Area 0.0.0.0 interface 10.0.0.1(POS5/1/1)'s neighbors
Router ID: 3.3.3.3 Address: 10.0.0.2 GR State: Normal
State: Full Mode:Nbr is Master Priority: 1
DR: None BDR: None
Dead timer due in 30 sec
Neighbor is up for 00:01:00
Authentication Sequence: [ 0 ]
[PE1] display ip routing-table
Routing Tables: Public
Destinations : 7 Routes : 7
Destination/Mask Proto Pre Cost NextHop Interface
2.2.2.2/32 Direct 0 0 127.0.0.1 InLoop0
3.3.3.3/32 OSPF 10 1563 10.0.0.2 POS5/1/1
10.0.0.0/24 Direct 0 0 10.0.0.1 POS5/1/1
10.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
10.0.0.2/32 Direct 0 0 10.0.0.2 POS5/1/1
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
2. Configure basic MPLS TE, and enable RSVP-TE and CSPF:
# Configure PE 1.
[PE1] mpls lsr-id 2.2.2.2
[PE1] mpls
[PE1-mpls] lsp-trigger all
[PE1-mpls] mpls te
[PE1-mpls] mpls rsvp-te
[PE1-mpls] mpls te cspf
[PE1-mpls] quit
[PE1] interface pos 5/1/1
[PE1-POS5/1/1] mpls
[PE1-POS5/1/1] mpls te
[PE1-POS5/1/1] mpls rsvp-te
[PE1-POS5/1/1] quit
# Configure PE 2.
[PE2] mpls lsr-id 3.3.3.3
[PE2] mpls
[PE2-mpls] lsp-trigger all
[PE2-mpls] mpls te
[PE2-mpls] mpls rsvp-te
[PE2-mpls] mpls te cspf
[PE2-mpls] quit
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] mpls
[PE2-POS5/1/1] mpls te