R3303-HP HSR6800 Routers MPLS Configuration Guide
162
• The LDP session between the two endpoint PEs of the primary VC (for example, the LDP session
between PE 1 and PE 2 in Figure 44) goe
s down, causing deletion of the primary VC.
• A VC switchover command is executed.
MPLS L2VPN configuration task list
To set up a remote VC connection between two PEs, complete the following tasks:
• Configure an IGP on PEs and P devices to ensure IP connectivity in the backbone.
• Configure MPLS, GRE, or MPLS TE to set up public tunnels across the backbone network.
• Configure a tunneling policy on PEs to select the public tunnels that carry the VC.
• Configure MPLS L2VPN on PEs, set up the VC, and bind the ACs to the VC.
To set up a local VC connection, you only need to bind two ACs on the PE.
This document only describes the MPLS L2VPN-related configurations on PEs. The MPLS L2VPN is
transparent to a user network. You do not need to perform MPLS L2VPN-specific configurations on CEs.
To configure MPLS L2VPN on a PE:
Task Remarks
Configuring basic MPLS L2VPN
Required.
Perform this task to enable MPLS L2VPN. You can
perform other MPLS L2VPN configurations only after
you enable MPLS L2VPN.
Configuring a PE-CE interface
Required.
Perform this task to set up an AC between a PE and a
CE.
Configuring CCC MPLS L2VPN
Use one of the methods according to the MPLS L2VPN
implementation method.
For a remote connection, perform this task to set up a
VC, and bind the VC to an AC.
For a local connection, perform this task to bind two
ACs on a PE.
Configuring SVC MPLS L2VPN
Configuring Martini MPLS L2VPN
Configuring Kompella MPLS L2VPN
Creating a VC on a Layer 3 interface disables the IP related functions on the sub-interfaces of the Layer
3 interface. For example, the sub-interfaces cannot receive ARP or IGMP packets. They cannot forward
unicast or multicast packets. After you remove the VC, the IP related functions on the sub-interfaces
recover.
Configuring basic MPLS L2VPN
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Configure the LSR ID.
mpls lsr-id lsr-id N/A
3. Configure basic MPLS and
enter MPLS view.
mpls N/A