R3303-HP HSR6800 Routers MPLS Configuration Guide

164
Ste
p
Command Remarks
2. Enter interface view.
interface { serial | pos }
interface-number
After you configure FR DLCI or FR
port mode encapsulation on a
serial interface, you must use the
reset fr inarp command to clear FR
dynamic address mappings
between the PE and the CE. For
more information about the reset fr
inarp command, see Layer
2—WAN Command Reference.
3. Configure the link layer
protocol.
link-protocol fr [ nonstandard |
ietf ]
By default, the link layer protocol
of an interface is PPP.
4. Enter FR point-to-point
subinterface view.
interface { serial | pos }
interface-number.subnumber p2p
Required for FR DLCI
encapsulation.
5. Create a virtual circuit.
fr dlci dlci-number
By default, no virtual circuit exists.
Required for FR DLCI
encapsulation.
The DLCI number must be the same
as that configured on the
connected CE.
Configuring the interface with Ethernet encapsulation
Ethernet interfaces use Ethernet encapsulation. For configuration information about Ethernet interfaces,
see Interface Configuration Guide.
Configuring the interface with VLAN encapsulation
Ethernet subinterfaces use VLAN encapsulation. For more information about Ethernet subinterface
configuration, see Interface Configuration Guide.
Configuring the interface with transparent ATM AAL5 frame
encapsulation
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter ATM point-to-point
interface view or subinterface
view.
interface atm { interface-number |
interface-number.subnumber } p2p
N/A
3. Create a Permanent Virtual
Circuit (PVC) and enter PVC
view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
No PVC exists by default.
You must configure the same
VPI/VCI values as those
configured on the connected CE.