R3303-HP HSR6800 Routers MPLS Configuration Guide

185
# Configure OSPF on PE 2 for establishing LSPs.
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 10.2.2.1 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 192.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# Create a static VC on the interface connected to CE 2. The interface requires no IP address.
[PE2] interface pos 5/1/1
[PE2-POS5/1/1] link-protocol ppp
[PE2-POS5/1/1] mpls static-l2vc destination 192.2.2.2 transmit-vpn-label 200
receive-vpn-label 100
[PE2-POS5/1/1] quit
5. Configure CE 2:
# Configure the link protocol as PPP on interface POS 5/1/0 (the interface connected to PE 2),
and configure an IP address for the interface.
<Sysname> system-view
[Sysname] sysname CE2
[CE2] interface pos 5/1/0
[CE2-POS5/1/0] link-protocol ppp
[CE2-POS5/1/0] ip address 100.1.1.2 24
Verifying the configuration:
# Display static VC information on PE 1. The output shows that a VC has been established.
[PE1] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
POS5/1/0 up 192.3.3.3 100 200 -
# Display static VC information on PE 2. The output shows that a VC has been established.
[PE2] display mpls static-l2vc
Total connections: 1, 1 up, 0 down
ce-intf state destination tr-label rcv-label tnl-policy
POS5/1/1 up 192.2.2.2 200 100 -
# Ping CE 2 from CE 1. The output shows that CE 1 and CE 2 can ping each other.
[CE1] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=150 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=130 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=140 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms