R3303-HP HSR6800 Routers MPLS Configuration Guide

187
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure the peer relationship with PE 2 so that the LDP remote session can be established
between them.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 192.3.3.3
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected to the P device, and enable LDP on the interface.
[PE1] interface serial 2/1/1
[PE1-Serial2/1/1] link-protocol ppp
[PE1-Serial2/1/1] ip address 10.1.1.1 24
[PE1-Serial2/1/1] mpls
[PE1-Serial2/1/1] mpls ldp
[PE1-Serial2/1/1] quit
# Configure OSPF on PE 1 for establishing LSPs.
[PE1] ospf
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 10.1.1.1 0.0.0.255
[PE1-ospf-1-area-0.0.0.0] network 192.2.2.2 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Create a Martini VC on the interface connected to CE 1. The interface requires no IP address.
[PE1] interface serial 2/1/0
[PE1-Serial2/1/0] mpls l2vc 192.3.3.3 101
[PE1-Serial2/1/0] quit
3. Configure the P device:
# Configure the LSR ID and enable MPLS globally.
<Sysname> system-view
[Sysname] sysname P
[P] interface loopback 0
[P-LoopBack0] ip address 192.4.4.4 32
[P-LoopBack0] quit
[P] mpls lsr-id 192.4.4.4
[P] mpls
[P-mpls] quit
# Enable LDP globally.
[P] mpls ldp
[P-mpls-ldp] quit
# Configure the interface connected to PE 1, and enable LDP on the interface.
[P] interface serial 2/1/0
[P-Serial2/1/0] link-protocol ppp