R3303-HP HSR6800 Routers MPLS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP HSR6804 Router Chassis

211

212

213

214

215

216

217

218

219

220

203

[P-Ten-GigabitEthernet1/0/2] ip address 23.1.1.2 24

[P-Ten-GigabitEthernet1/0/2] mpls

[P-Ten-GigabitEthernet1/0/2] mpls ldp

[P-Ten-GigabitEthernet1/0/2] quit

# Configure the interface connected with PE 2 and enable LDP on the interface.

[P] interface ten-GigabitEthernet1/0/3

[P-Ten-GigabitEthernet1/0/3] ip address 26.2.2.2 24

[P-Ten-GigabitEthernet1/0/3] mpls

[P-Ten-GigabitEthernet1/0/3] mpls ldp

[P-Ten-GigabitEthernet1/0/3] quit

# Configure OSPF.

[P] ospf

[P-ospf-1] area 0

[P-ospf-1-area-0.0.0.0] network 23.1.1.2 0.0.0.255

[P-ospf-1-area-0.0.0.0] network 26.2.2.2 0.0.0.255

[P-ospf-1-area-0.0.0.0] network 192.4.4.4 0.0.0.0

[P-ospf-1-area-0.0.0.0] quit

[P-ospf-1] quit

4. Configure PE 2:

<Sysname> system-view

[Sysname] sysname PE2

[PE2] interface loopback 0

[PE2-LoopBack0] ip address 192.3.3.3 32

[PE2-LoopBack0] quit

# Configure the MPLS LSR ID and enable MPLS globally.

[PE2] mpls lsr-id 192.3.3.3

[PE2] mpls

[PE2-mpls] quit

# Enable L2VPN and MPLS L2VPN.

[PE2] l2vpn

[PE2-l2vpn] mpls l2vpn

[PE2-l2vpn] quit

# Enable LDP globally.

[PE2] mpls ldp

[PE2-mpls-ldp] quit

# Configure PE 2 to establish a remote LDP connection with PE 1.

[PE2] mpls ldp remote-peer 2

[PE2-mpls-ldp-remote-2] remote-ip 192.2.2.2

[PE2-mpls-ldp-remote-2] quit

# Configure the interface connected with the P device and enable LDP on the interface.

[PE2] interface ten-GigabitEthernet 1/0/3

[PE2-Ten-GigabitEthernet1/0/3] ip address 26.2.2.1 24

[PE2-Ten-GigabitEthernet1/0/3] mpls

[PE2-Ten-GigabitEthernet1/0/3] mpls ldp

[PE2-Ten-GigabitEthernet1/0/3] quit

# Configure OSPF.