R3303-HP HSR6800 Routers MPLS Configuration Guide

216
Step Command Remarks
5. Return to system view.
quit N/A
6. Create an LDP VPLS instance
and enter VSI view.
vsi vsi-name static [ p2p ] N/A
7. Specify LDP as the PW
signaling protocol and enter
VSI LDP view.
pwsignal ldp N/A
8. Specify an ID for the VPLS
instance.
vsi-id vsi-id N/A
9. Create a peer PE for the VPLS
instance and enter L2VPN
peer view.
peer ip-address [ pw-class
class-name | [ pw-id pw-id ] [ upe
| backup-peer ip-address
[ backup-pw-id pw-id ] ] ] *
N/A
10. Return to VSI LDP view.
quit N/A
11. Enable the PW switchover
function and set the
switchover delay time.
dual-npe revertive [ wtr-time
wtr-time ]
Optional.
By default, PW switchover is
disabled.
NOTE:
• The PW to PW (P2P) mode VSI is applicable only to point to point MPLS L2VPN.
• To configure a multi-hop PW, specify the p2p keyword when you create a VPLS instance to enable the
P2P capability, and specify the two peer PEs by using the peer command in the VPLS instance view to
associate two PWs.
• Up to two peer PEs can be specified for a P2P enabled VPLS instance, and one of them must be specified
as a UPE.
Configuring BGP VPLS
Before you configure BGP VPLS, complete the following tasks:
• Configure an IGP on the MPLS backbone devices (PEs and P devices) to guarantee the IP
connectivity of the MPLS backbone. For configuration information, see Layer 3—IP Routing
Configuration Guide.
• Configure basic MPLS on the MPLS backbone devices (PEs and P devices) to establish LSP tunnels
on the backbone network. For configuration information, see "Configuring basic MPLS."
Configuring the BGP extension
Before configuring BGP VPLS, you must configure BGP parameters on the PEs. For configuration details,
see Layer 3—IP Routing Configuration Guide.
To configure the BGP extension:
Step Command Remarks
1. Enter system view.
system-view N/A