R3303-HP HSR6800 Routers MPLS Configuration Guide

219
Ste
p
Command Remarks
3. Create a service instance and
enter its view.
service-instance service-instance-id
By default, no service instance is
created.
4. Configure a packet matching
rule for the service instance.
encapsulation { port-based | s-vid
vlan-id [ only-tagged ] | tagged |
untagged }
By default, no packet matching rule
is configured for a service
instance.
5. Bind the service instance to a
VPLS instance.
xconnect vsi vsi-name
[ access-mode { ethernet | vlan } ] *
By default, a service instance is not
bound to any VPLS instance.
This command is available for
service instances with IDs in the
range of 1 to 4094.
Configuring MAC address learning
To configure the MAC address learning function:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSI view.
vsi vsi-name N/A
3. Enable or disable MAC
address learning for the VPLS
instance.
mac-learning { enable | disable }
Optional.
Enabled by default.
4. Set the maximum number of
MAC addresses that the
device can learn for the VPLS
instance.
mac-table limit mac-limit-number
Optional.
The default limit is 16384.
5. Configure the device to drop
packets with unknown source
MAC addresses after it has
learned the maximum number
of MAC addresses for the
VPLS instance.
mac-table limit drop-unknown
Optional.
By default, the device forwards
packets with unknown source
MAC addresses after it has
learned the maximum number of
MAC addresses.
Configuring VPLS instance attributes
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSI view.
vsi vsi-name N/A
3. Specify the upper speed limit
for the VPLS instance.
bandwidth vpn-speed
Optional.
102400 kbps by default.
4. Specify the broadcast
suppression ratio for the VPLS
instance.
broadcast-restrain ratio
Optional.
5 percent by default.