R3303-HP HSR6800 Routers MPLS Configuration Guide

222
• Configure VPLS instance aaa to use LDP (Martini mode) and VPLS instance bbb to use BGP
(Kompella mode), and configure the AS number as 100.
• Configure service instance 1 to match packets that are received on interface Ten-GigabitEthernet
1/0/1 and carry the VLAN tag of 100. Bind service instance 1 to VPLS instance aaa.
• Configure service instance 2 to match packets that are received on interface Ten-GigabitEthernet
1/0/1 and carry VLAN tag of 200. Bind service instance 2 to VPLS instance bbb.
Figure 59 Network diagram
Configuration procedure
1. Configure PE 1:
# Configure an IP address for loopback 0.
<Sysname> system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
# Configure the LSR ID and enable MPLS globally.
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
# Enable L2VPN and MPLS L2VPN.
[PE1] l2vpn
[PE1-l2vpn] mpls l2vpn
[PE1-l2vpn] quit
# Enable LDP globally.
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure PE 1 to establish an LDP remote session with PE 2.
[PE1] mpls ldp remote-peer 1
[PE1-mpls-ldp-remote-1] remote-ip 3.3.3.9
[PE1-mpls-ldp-remote-1] quit
# Configure the interface connected to the P device and enable LDP on the interface.
[PE1] interface ten-GigabitEthernet 1/0/2
[PE1-Ten-GigabitEthernet1/0/2] ip address 23.1.1.1 24
[PE1-Ten-GigabitEthernet1/0/2] mpls
[PE1-Ten-GigabitEthernet1/0/2] mpls ldp
CE 1
CE 2
PE 1 PE 2P
XGE1/0/2
23.1.1.1/24
XGE1/0/2
23.1.1.2/24
XGE1/0/3
26.2.2.2/24
XGE1/0/3
26.2.2.1/24
XGE1/0/1 XGE1/0/1
Loop0
1.1.1.9/32
Loop0
2.2.2.9/32
Loop0
3.3.3.9/32