R3303-HP HSR6800 Routers MPLS Configuration Guide

19
Label advertisement control
Label advertisement control is for filtering label bindings to be advertised. A downstream LSR advertises
only the label bindings of the specified FECs to the specified upstream LSR. As shown in Figure 9,
do
wnstream device LSR A advertises to upstream device LSR B only label bindings with FEC destinations
permitted by prefix list B, and advertises to upstream device LSR C only label bindings with FEC
destinations permitted by prefix list C.
Figure 9 Network diagram of label advertisement control
Configuration prerequisites
Before you configure LDP label filtering policies, create an IP prefix list. For information about IP prefix list
configuration, see Layer 3—IP Routing Configuration Guide.
Configuration procedure
For two neighboring LSRs, configuring a label acceptance policy on the upstream LSR and configuring
a label advertisement policy on the downstream LSR have the same effect. To reduce network traffic, HP
recommends that you configure only label advertisement control policies.
To configure LDP label filtering policies:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS LDP view.
mpls ldp N/A
3. Configure a label
acceptance policy.
accept-label peer peer-id ip-prefix ip-prefix-name
Optional.
Not configured by
default.
4. Configure a label
advertisement policy.
advertise-label ip-prefix ip-prefix-name [ peer
peer-ip-prefix-name ]
Not configured by
default.
Maintaining LDP sessions
This section describes how to detect communication failures between remote LDP peers and reset LDP
sessions.
Adv
e
rtis
e
label
bindings
per
mit
t
ed
b
y
p
refix list C