R3303-HP HSR6800 Routers MPLS Configuration Guide

297
Ste
p
Command Remarks
4. Redistribute the IGP routes of
the VPN.
import-route protocol [ process-id ]
[ med med-value | route-policy
route-policy-name ] *
Optional.
A VPN site must advertise the VPN
network addresses it can reach to
the connected MCE.
Configuring routing between MCE and PE
MCE-PE routing configuration includes these tasks:
• Bind the MCE-PE interfaces to VPN instances.
• Perform route configurations.
• Redistribute VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on MCE. Configurations on the PE are similar to those on the PE
in common MPLS L3VPN network solutions (see "Configuring static routing between a PE and a CE")
.
Configuring static routing between MCE and PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a static route
for a VPN instance.
• ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
• ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number [ gateway-address ]
| vpn-instance d-vpn-instance-name
gateway-address } [ preference preference-value ]
[ tag tag-value ] [ description description-text ]
Use either
command as
needed.
3. Configure the default
precedence for static
routes.
ip route-static default-preference
default-preference-value
Optional.
60 by default.
Configuring RIP between MCE and PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIP process for
a VPN instance and
enter RIP view.
rip [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Enable RIP on the
interface attached to
the specified network.
network network-address
By default, RIP is disabled on
an interface.