R3303-HP HSR6800 Routers MPLS Configuration Guide

316
After the configurations, P establishes an LDP session with PE 1 and PE 2 respectively. Execute the
display mpls ldp session command. The output shows that the session status is Operational.
Execute the display mpls ldp lsp command. The output shows the LSPs established by LDP. Take PE
1 as an example:
[PE1] display mpls ldp session
LDP Session(s) in Public Network
Total number of sessions: 1
----------------------------------------------------------------
Peer-ID Status LAM SsnRole FT MD5 KA-Sent/Rcv
---------------------------------------------------------------
2.2.2.9:0 Operational DU Passive Off Off 5/5
---------------------------------------------------------------
LAM : Label Advertisement Mode FT : Fault Tolerance
[PE1] display mpls ldp lsp
LDP LSP Information
------------------------------------------------------------------
SN DestAddress/Mask In/OutLabel Next-Hop In/Out-Interface
------------------------------------------------------------------
1 1.1.1.9/32 3/NULL 127.0.0.1 -------/InLoop0
2 2.2.2.9/32 NULL/3 172.1.1.2 -------/POS5/1/1
3 3.3.3.9/32 NULL/1024 172.1.1.2 -------/POS5/1/1
------------------------------------------------------------------
A '*' before an LSP means the LSP is not established
A '*' before a Label means the USCB or DSCB is stale
3. Configure VPN instances on PEs to allow CEs to access:
# Configure PE 1.
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 111:1
[PE1-vpn-instance-vpn1] quit
[PE1] ip vpn-instance vpn2
[PE1-vpn-instance-vpn2] route-distinguisher 100:2
[PE1-vpn-instance-vpn2] vpn-target 222:2
[PE1-vpn-instance-vpn2] quit
[PE1] interface gigabitethernet 2/1/1
[PE1-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
[PE1-GigabitEthernet2/1/1] ip address 10.1.1.2 24
[PE1-GigabitEthernet2/1/1] quit
[PE1] interface gigabitethernet 2/1/2
[PE1-GigabitEthernet2/1/2] ip binding vpn-instance vpn2
[PE1-GigabitEthernet2/1/2] ip address 10.2.1.2 24
[PE1-GigabitEthernet2/1/2] quit
# Configure PE 2.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 200:1
[PE2-vpn-instance-vpn1] vpn-target 111:1
[PE2-vpn-instance-vpn1] quit
[PE2] ip vpn-instance vpn2