R3303-HP HSR6800 Routers MPLS Configuration Guide

383
[PE1-GigabitEthernet3/1/1.2] ip binding vpn-instance vpn2
[PE1-GigabitEthernet3/1/1.2] vlan-type dot1q vid 20
[PE1-GigabitEthernet3/1/1.2] ip address 30.1.1.2 24
[PE1-GigabitEthernet3/1/1.2] quit
# Configure the IP address of the interface Loopback0 as 101.101.10.1 for the MCE and as
100.100.10.1 for PE 1. Specify the loopback interface address as the router ID for the MCE and
PE 1. (Details not shown.)
# Enable OSPF process 10 on the MCE, bind the process to VPN instance vpn1, and set the
domain ID to 10.
[MCE] ospf 10 router-id 101.101.10.1 vpn-instance vpn1
[MCE-ospf-10] vpn-instance-capability simple
[MCE-ospf-10] domain-id 10
# Advertise subnet 20.1.1.0/24 in area 0, and redistribute the static route of VPN 1.
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[MCE-ospf-10-area-0.0.0.0] quit
[MCE-ospf-10] import-route static
# On PE 1, enable OSPF process 10, bind the process to VPN instance vpn1, set the domain ID
to 10, and advertise subnet 20.1.1.0/24 in area 0.
[PE1] ospf 10 router-id 100.100.10.1 vpn-instance vpn1
[PE1-ospf-10] domain-id 10
[PE1-ospf-10] area 0
[PE1-ospf-10-area-0.0.0.0] network 20.1.1.0 0.0.0.255
[PE1-ospf-10-area-0.0.0.0] quit
[PE1-ospf-10] quit
# On PE 1, display the routing information for VPN 1.
[PE1] display ip routing-table vpn-instance vpn1
Routing Tables: vpn1
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost NextHop Interface
20.1.1.0/24 Direct 0 0 20.1.1.2 GE3/1/1.1
20.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
192.168.0.0/24 O_ASE 150 1 20.1.1.1 GE3/1/1.1
The output shows that the static route of VPN 1 has been redistributed to the OSPF routing table of
PE 1.
Take similar procedures to configure OSPF process 20 between the MCE and PE 1 and
redistribute VPN 2's routing information from RIP into the OSPF routing table of the MCE. The
following output shows that PE 1 has learned the private route of VPN 2 through OSPF.
[PE1] display ip routing-table vpn-instance vpn2
Routing Tables: vpn2
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost NextHop Interface
30.1.1.0/24 Direct 0 0 30.1.1.2 GE3/1/1.2
30.1.1.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0