R3303-HP HSR6800 Routers MPLS Configuration Guide

401
Ste
p
Command Remarks
8. Apply the tunneling policy to
the VPN instance.
tnl-policy tunnel-policy-name
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel, GRE tunnel,
CR-LSP tunnel.
The tunneling policy to be applied
must have existed. Otherwise, the
default tunneling policy is used. The
default tunneling policy selects only
one tunnel in this order: LSP tunnel,
GRE tunnel, CR-LSP tunnel.
NOTE:
• A tunneling policy configured in VPN instance view is applicable to both IPv4 VPNs and IPv6 VPNs.
• You can configure a tunneling policy for IPv6 VPNs in both VPN instance view and IPv6 VPN view. A
tunneling policy configured in IPv6 VPN view takes precedence.
Configuring an LDP instance
LDP instances are for carrier's carrier network applications.
This task is to enable LDP for an existing VPN instance, create an LDP instance for the VPN instance, and
configure LDP parameters for the LDP instance.
For LDP instance configuration information, see "Configuring MPLS L3VPN"
Configuring routing between a PE and a CE
You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, or EBGP between a PE and a CE.
Before configuring routing between a PE and a CE, complete the following tasks:
• Assign an IPv6 address to the CE-PE interface of the CE
• Assign an IPv6 address to the PE-CE interface of the PE
Configuring IPv6 static routing between a PE and a CE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 static
route for a VPN instance.
• ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
• ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address
[ public ] | vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
Use either command as
needed.
Perform this configuration
on PEs. On CEs, configure
normal IPv6 static routes.
For more information
about IPv6 static routing,
see Layer 3—IP Routing
Configuration Guide.