R3303-HP HSR6800 Routers MPLS Configuration Guide

405
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Configure the remote PE as
the peer.
peer ip-address as-number
as-number
N/A
4. Specify the interface for TCP
connections.
peer ip-address connect-interface
interface-type interface-number
N/A
5. Enter BGP-VPNv6 subaddress
family view.
ipv6-family vpnv6 N/A
6. Set the default value of the
local preference.
default local-preference value
Optional.
100 by default.
7. Set the default value for the
system MED.
default med med-value
Optional.
By default, the default value of the
system MED is 0.
8. Configure a filtering policy to
filter routes to be advertised.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ direct | isisv6 process-id |
ripng process-id | static ]
Optional.
By default, the PE does not filter
routes to be advertised.
9. Configure a filtering policy to
filter received routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
Optional.
By default, the PE does not filter
received routes.
10. Apply a filtering policy for the
peer.
peer ip-address filter-policy
acl6-number { export | import }
Optional.
By default, no filtering policy is
applied for a peer.
11. Apply an IPv6-prefix list for
the peer to filter
received/advertised routes.
peer ip-address ipv6-prefix
prefix-name { export | import }
Optional.
By default, no IPv6 prefix list is
applied for a peer.
12. Specify the preference value
for the routes received from
the peer.
peer ip-address preferred-value
value
Optional.
0 by default.
13. Configure BGP updates to the
peer to not carry private AS
numbers.
peer ip-address public-as-only
Optional.
By default, a BGP update carries
private AS numbers.
14. Apply a routing policy for the
peer.
peer ip-address route-policy
route-policy-name { export |
import }
Optional.
By default, no routing policy is
applied for a peer.
15. Enable route target filtering
for received BGP-VPNv6
subaddress family routes.
policy vpn-target
Optional.
Enabled by default.
16. Configure the local PE as the
route reflector and specify the
peer as the client.
peer ip-address reflect-client
Optional.
No route reflector or client is
configured by default.
17. Enable route reflection
between clients.
reflect between-clients
Optional.
Enabled by default.