R3303-HP HSR6800 Routers MPLS Configuration Guide

409
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
ripng [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
3. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
By default, no route of any other
routing protocol is redistributed
into RIPng.
4. Configure the default cost
value for the redistributed
routes.
default cost value
Optional.
0 by default.
5. Return to system view.
quit
N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable RIPng on the interface.
ripng process-id enable Disabled by default.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3 processes,
ensuring the separation and security of IPv6 VPN routes.
To configure OSPFv3 between an MCE and a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
Perform this configuration on the
MCE. On a VPN site, configure
normal OSPFv3.
3. Set the router ID.
router-id router-id N/A
4. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable OSPFv3 on the
interface.
ospfv3 process-id area area-id
[ instance instance-id ]
By default, OSPFv3 is disabled on
an interface.
NOTE:
Deleting a VPN instance also deletes all related OSPFv3 processes at the same time.