R3303-HP HSR6800 Routers MPLS Configuration Guide

411
Ste
p
Command Remarks
3. Enter IPv6 BGP-VPN instance
view.
ipv6-family vpn-instance
vpn-instance-name
N/A
4. Specify an IPv6 BGP peer in
an AS.
peer ipv6-address as-number
as-number
N/A
5. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
By default, No route redistribution
is configured.
6. Configure a filtering policy to
filter the routes to be
advertised.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } export
[ direct | isisv6 process-id | ripng
process-id | static ]
Optional.
By default, the MCE does not filter
the routes to be advertised.
7. Configure a filtering policy to
filter the received routes.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name } import
Optional.
By default, the MCE does not filter
the received routes.
NOTE:
A
fter you confi
g
ure an IPv6 BGP VPN instance, the IPv6 BGP route exchange for the IPv6 VPN instance is
the same with the normal IPv6 BGP VPN route exchange. For more information about IPv6 BGP, see
Laye
r
3—IP Routing Configuration Guide .
2. Configure the VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure the MCE as the
EBGP peer.
peer ipv6-address as-number
as-number
N/A
5. Redistribute the IGP routes of
the VPN.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Optional.
By default, no route redistribution
is configured.
A VPN site must advertise the IPv6
VPN network addresses it can
reach to the connected MCE.
Configuring routing between an MCE and a PE
MCE-PE routing configuration includes these tasks:
• Bind the MCE-PE interfaces to IPv6 VPN instances
• Perform routing configurations
• Redistribute IPv6 VPN routes into the routing protocol running between the MCE and the PE.