R3303-HP HSR6800 Routers MPLS Configuration Guide

412
Perform the following configuration tasks on the MCE. Configurations on the PE are similar to those on the
PE in common IPv6 MPLS L3VPN network solutions. For more information, see "Configuring routing
bet
ween a PE and a CE"
Configuring IPv6 static routing between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure an IPv6 static
route for an IPv6 VPN
instance.
• ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number [ next-hop-address ]
| next-hop-address | vpn-instance
d-vpn-instance-name nexthop-address } [ preference
preference-value ]
• ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ] |
vpn-instance d-vpn-instance-name nexthop-address }
[ preference preference-value ]
User either
command as
needed.
Configuring RIPng between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Create a RIPng process for an
IPv6 VPN instance and enter
RIPng view.
ripng [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Redistribute the VPN routes.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
By default, no route of any other
routing protocol is redistributed
into RIPng.
4. Configure the default cost
value for the redistributed
routes.
default cost value
Optional.
0 by default.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable the RIPng process on
the interface.
ripng process-id enable Disabled by default.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
Configuring OSPFv3 between an MCE and a PE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPFv3 process for
an IPv6 VPN instance and
enter OSPFv3 view.
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
N/A