R3303-HP HSR6800 Routers MPLS Configuration Guide

435
2. Configure ASBR-PE 1:
# Start IS-IS on ASBR-PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] isis 1
[ASBR-PE1-isis-1] network-entity 10.2222.2222.2222.00
[ASBR-PE1-isis-1] quit
# Configure an LSR ID, and enable MPLS and LDP.
[ASBR-PE1] mpls lsr-id 3.3.3.9
[ASBR-PE1] mpls
[ASBR-PE1-mpls] label advertise non-null
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
# Configure interface Serial 2/1/1, and start IS-IS and enable MPLS and LDP on the interface.
[ASBR-PE1] interface serial 2/1/1
[ASBR-PE1-Serial2/1/1] ip address 1.1.1.1 255.0.0.0
[ASBR-PE1-Serial2/1/1] isis enable 1
[ASBR-PE1-Serial2/1/1] mpls
[ASBR-PE1-Serial2/1/1] mpls ldp
[ASBR-PE1-Serial2/1/1] quit
# Configure interface Serial 2/1/2 and enable MPLS on it.
[ASBR-PE1] interface serial 2/1/2
[ASBR-PE1-Serial2/1/2] ip address 11.0.0.2 255.0.0.0
[ASBR-PE1-Serial2/1/2] mpls
[ASBR-PE1-Serial2/1/2] quit
# Configure interface Loopback 0 and start IS-IS on it.
[ASBR-PE1] interface loopback 0
[ASBR-PE1-LoopBack0] ip address 3.3.3.9 32
[ASBR-PE1-LoopBack0] isis enable 1
[ASBR-PE1-LoopBack0] quit
# Create routing policies.
[ASBR-PE1] route-policy policy1 permit node 1
[ASBR-PE1-route-policy1] apply mpls-label
[ASBR-PE1-route-policy1] quit
[ASBR-PE1] route-policy policy2 permit node 1
[ASBR-PE1-route-policy2] if-match mpls-label
[ASBR-PE1-route-policy2] apply mpls-label
[ASBR-PE1-route-policy2] quit
# Start BGP on ASBR-PE 1 and redistribute routes from IS-IS process 1.
[ASBR-PE1] bgp 100
[ASBR-PE1-bgp] import-route isis 1
# Apply routing policy policy2 to filter routes advertised to IBGP peer 2.2.2.9.
[ASBR-PE1-bgp] peer 2.2.2.9 as-number 100
[ASBR-PE1-bgp] peer 2.2.2.9 route-policy policy2 export
# Configure the capability to advertise labeled routes to and receive labeled routes from IBGP
peer 2.2.2.9.