R3303-HP HSR6800 Routers MPLS Configuration Guide

436
[ASBR-PE1-bgp] peer 2.2.2.9 connect-interface loopback 0
[ASBR-PE1-bgp] peer 2.2.2.9 label-route-capability
# Apply routing policy policy1 to filter routes advertised to EBGP peer 11.0.0.1.
[ASBR-PE1-bgp] peer 11.0.0.1 as-number 600
[ASBR-PE1-bgp] peer 11.0.0.1 route-policy policy1 export
# Configure the capability to advertise labeled routes to and receive labeled routes from EBGP
peer 11.0.0.1.
[ASBR-PE1-bgp] peer 11.0.0.1 label-route-capability
[ASBR-PE1-bgp] quit
3. Configure ASBR-PE 2:
# Start IS-IS on ASBR-PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] isis 1
[ASBR-PE2-isis-1] network-entity 10.3333.3333.3333.3333.00
[ASBR-PE2-isis-1] quit
# Configure an LSR ID, and enable MPLS and LDP.
[ASBR-PE2] mpls lsr-id 4.4.4.9
[ASBR-PE2] mpls
[ASBR-PE2-mpls] label advertise non-null
[ASBR-PE2-mpls] quit
[ASBR-PE2] mpls ldp
[ASBR-PE2-mpls-ldp] quit
# Configure interface Serial 2/1/1, and start IS-IS and enable MPLS and LDP on the interface.
[ASBR-PE2] interface serial 2/1/1
[ASBR-PE2-Serial2/1/1] ip address 9.1.1.1 255.0.0.0
[ASBR-PE2-Serial2/1/1] isis enable 1
[ASBR-PE2-Serial2/1/1] mpls
[ASBR-PE2-Serial2/1/1] mpls ldp
[ASBR-PE2-Serial2/1/1] quit
# Configure interface Loopback 0 and start IS-IS on it.
[ASBR-PE2] interface loopback 0
[ASBR-PE2-LoopBack0] ip address 4.4.4.9 32
[ASBR-PE2-LoopBack0] isis enable 1
[ASBR-PE2-LoopBack0] quit
# Configure interface Serial 2/1/2 and enable MPLS on it.
[ASBR-PE2] interface serial 2/1/2
[ASBR-PE2-Serial2/1/2] ip address 11.0.0.1 255.0.0.0
[ASBR-PE2-Serial2/1/2] mpls
[ASBR-PE2-Serial2/1/2] quit
# Create routing policies.
[ASBR-PE2] route-policy policy1 permit node 1
[ASBR-PE2-route-policy1] apply mpls-label
[ASBR-PE2-route-policy1] quit
[ASBR-PE2] route-policy policy2 permit node 1
[ASBR-PE2-route-policy2] if-match mpls-label
[ASBR-PE2-route-policy2] apply mpls-label