R3303-HP HSR6800 Routers MPLS Configuration Guide

440
Figure 109 Network diagram
Device Interface IP address Device Interface IP address
CE 3 GE2/1/1 2001:1::1/96 CE 4 GE2/1/1 2001:2::1/96
PE 3 Loop0 1.1.1.9/32 PE 4 Loop0 6.6.6.9/32
GE2/1
/
1 2001:1::2/96 GE2/1
/
1 2001:2::2/96
POS5/1/2 10.1.1.1/24 POS5/1/2 20.1.1.2/24
CE 1 Loop0 2.2.2.9/32 CE 2 Loop0 5.5.5.9/32
POS5/1/1 10.1.1.2/24 POS5/1/1 21.1.1.2/24
POS5/1/2 11.1.1.1/24 POS5/1/2 20.1.1.1/24
PE 1 Loop0 3.3.3.9/32 PE 2 Loop0 4.4.4.9/32
POS5/1/1 11.1.1.2/24 POS5/1/1 30.1.1.2/24
POS5/1/2 30.1.1.1/24 POS5/1/2 21.1.1.1/24
Configuration procedure
1. Configure MPLS L3VPN on the provider carrier backbone—start IS-IS as the IGP, enable LDP on PE
1 and PE 2, and establish an MP-IBGP peer relationship between the PEs:
# Configure PE 1.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 3.3.3.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 3.3.3.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] isis 1
[PE1-isis-1] network-entity 10.0000.0000.0004.00
[PE1-isis-1] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1