R3303-HP HSR6800 Routers MPLS Configuration Guide

55
Ste
p
Command Remarks
9. Assign an IP address to the
tunnel interface.
ip address ip-address netmask Optional.
10. Set the tunnel protocol to
MPLS TE.
tunnel-protocol mpls te N/A
11. Configure the destination
address of the tunnel.
destination ip-address N/A
12. Configure the tunnel ID of the
tunnel.
mpls te tunnel-id tunnel-id N/A
13. Submit the current tunnel
configuration.
mpls te commit N/A
For information about tunnel interfaces, see Layer 3—IP Services Configuration Guide.
Configuring DiffServ-aware TE
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS view.
mpls N/A
3. Configure the DS-TE mode as
IETF.
mpls te ds-te mode ietf
Optional.
By default, the DS-TE mode is
prestandard.
4. Configure the BC model of
IETF DS-TE as MAM.
mpls te ds-te ietf bc-mode mam
Optional.
By default, the BC model of IETF
DS-TE is RDM.
5. Configure the TE class
mapping in IETF DS-TE mode,
or, the TE class-CT-priority
association.
mpls te ds-te ietf te-class
te-class-index class-type
class-type-number priority
pri-number
Optional.
By default, the TE class mappings in
IETF mode are as shown in Table 1.
Table 1 Default TE class mappings in IETF mode
TE Class CT
Priorit
y
0 0 7
1 1 7
2 2 7
3 3 7
4 0 0
5 1 0
6 2 0
7 3 0