R3303-HP HSR6800 Routers MPLS Configuration Guide

58
Task Remarks
Configuring MPLS TE properties for a link Optional.
Configuring CSPF Optional.
Configuring OSPF TE
Required when CSPF is configured.
Choose one depending on the IGP protocol used.
Configuring IS-IS TE
Configuring an MPLS TE explicit path Optional.
Configuring MPLS TE tunnel constraints Optional.
Establishing an MPLS TE tunnel with CR-LDP Optional.
Use either method.
By default, RSVP-TE is used for establishing an MPLS
TE tunnel.
Establishing an MPLS TE tunnel with RSVP-TE
Configuring MPLS TE properties for a link
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view of MPLS
TE link.
interface interface-type
interface-number
N/A
3. Configure maximum link
bandwidth.
mpls te max-link-bandwidth
bandwidth-value
Optional.
0 by default.
4. Configure BC 0 and BC 1 of
the MPLS TE link in the RDM
model of the prestandard
DS-TE.
mpls te
max-reservable-bandwidth
bandwidth-value [ bc1
bc1-bandwidth ]
Optional.
0 for both BC 0 and BC 1 by
default.
In RDM model, BC 0 is the
maximum reservable bandwidth of
a link.
5. Configure maximum
reservable bandwidth and
BCs of the MPLS TE link in the
MAM model of the IETF
DS-TE.
mpls te
max-reservable-bandwidth mam
bandwidth-value { bc0
bc0-bandwidth | bc1
bc1-bandwidth | bc2
bc2-bandwidth | bc3
bc3-bandwidth } *
Optional.
By default, the maximum
bandwidth, and BC 0 through BC
3 are all 0.
6. Configure the BCs of the MPLS
TE link in the RDM model of
the IETF DS-TE.
mpls te
max-reservable-bandwidth rdm
bandwidth-value [ bc1
bc1-bandwidth ] [ bc2
bc2-bandwidth ] [ bc3
bc3-bandwidth ]
Optional.
0 for BC 0 through BC 3 by
default.
In RDM model, BC 0 is the
maximum reservable bandwidth of
a link.