R3303-HP HSR6800 Routers MPLS Configuration Guide

71
Ste
p
Command Remarks
3. Assign priorities to the tunnel.
mpls te priority setup-priority
[ hold-priority ]
Optional.
The default setup and holding
priorities are 7.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring traffic forwarding
Before you configure traffic forwarding, complete the following tasks:
• Configure basic MPLS.
• Configure basic MPLS TE.
• Configure MPLS TE tunnels.
Forwarding traffic along MPLS TE tunnels using static routes
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a static route for
forwarding traffic along an
MPLS TE tunnel.
ip route-static dest-address { mask
| mask-length } interface-type
interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name
gateway-address } [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
The interface-type argument must
be tunnel.
For more information about static
routing, see Layer 3—IP Routing
Configuration Guide.
Forwarding traffic along MPLS TE tunnels using policy routing
To configure policy routing for forwarding traffic along an MPLS TE tunnel:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create and enter the view
of an advanced IPv4 ACL.
acl number acl-number [ match-order { auto |
config } ]
The default ACL rule
match order is config.