R3303-HP HSR6800 Routers MPLS Configuration Guide

75
Ste
p
Command Remarks
2. Enter MPLS view.
mpls N/A
3. Specify the metric type to use
when no metric type is
explicitly configured for a
tunnel.
mpls te path metric-type { igp | te }
Optional.
TE metrics of links are used by
default.
4. Return to system view.
quit N/A
5. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number
If you do not configure the mpls te
path metric-type command in
MPLS TE tunnel interface view, the
configuration in MPLS view takes
effect.
6. Specify the metric type to use
for path calculation of the
current tunnel.
mpls te path metric-type { igp | te }
Optional.
By default, no link metric type is
specified and the one specified in
MPLS view is used.
7. Submit current tunnel
configuration.
mpls te commit Optional.
8. Return to system view.
quit N/A
9. Enter interface view of MPLS
TE link.
interface interface-type
interface-number
N/A
10. Assign a TE metric to the link.
mpls te metric value
Optional.
If no TE metric is assigned to the
link, IGP metric is used as the TE
metric by default.
Configuring the traffic flow type of a tunnel
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS TE tunnel interface
view.
interface tunnel tunnel-number N/A
3. Configure the traffic flow type
of the TE tunnel.
mpls te vpn-binding { acl
acl-number | vpn-instance
vpn-instance-name }
Optional.
Traffic flow types of TE tunnels are
not restricted by default.
4. Submit current tunnel
configuration.
mpls te commit N/A
Configuring automatic bandwidth adjustment
The configurations described in this section are used in conjunction with CSPF and the dynamic signaling
protocol CR-LDP or RSVP-TE.