R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

95
Statistics for packets received successfully:
Peak 10Sec 1Min 5Min Total-Data
------------------------------------------------------------
1 1 1 0 82
Statistics for packets acknowledged:
Peak 10Sec 1Min 5Min Total-Data
------------------------------------------------------------
1 1 1 0 78
Table 20 Command output
Field Descri
p
tion
Peak
Peak rate in pps (average rate is computed every 10 seconds,
and the greatest average rate is taken as the peak rate).
10Sec Average rate (in pps) in the last 10 seconds.
1Min Average rate (in pps) in the last 1 minute.
5Min Average rate (in pps) in the last 5 minutes.
Total-Data
Total amount of data collected from the time when IPC
performance statistics was enabled to the time when this
command is executed.
Related commands
ipc performance enable
display ipc queue
Use display ipc queue to display output queue information for the specified node.
Syntax
display ipc queue { node node-id | self-node } [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
node node-id: Displays channel information for the node specified by the node-id argument. In
standalone mode, the value range for the node-id argument is 0 to 13 for HSR6802, 0 to 15 for
HSR6804, and 0 to 19 for HSR6808. In IRF mode, the value range for the node-id argument is 0 to 39.
self-node: Specifies the local node.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.