R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

198
Views
System view
Default command level
3: Manage level
Parameters
seconds: Sets the aging timer for active flows, in the range of 10 to 3600 seconds.
Usage Guidelines
You can configure both the aging timer for active flows and the aging timer for inactive flows. When
either timer for a flow expires, the flow is aged out. The time precision is 10 seconds.
Examples
# Set the aging timer to 60 seconds for active flows.
<Sysname> system-view
[Sysname] ipv6 netstream timeout active 60
Related commands
ipv6 netstream timeout inactive
ipv6 netstream timeout inactive
Use ipv6 netstream timeout inactive to set the aging timer for inactive flows. This timer applies to only
NetStream traditional data flows.
Use undo ipv6 netstream timeout inactive to restore the default.
Syntax
ipv6 netstream timeout inactive seconds
undo ipv6 netstream timeout inactive
Default
The aging timer is 30 seconds for inactive flows.
Views
System view
Default command level
3: Manage level
Parameters
seconds: Sets the aging time for inactive flows, in the range of 10 to 600 seconds.
Usage Guidelines
You can configure both the aging timer for active flows and the aging timer for inactive flows. When
either timer for a flow expires, the flow is aged out. The time precision is 10 seconds.
Examples
# Set the aging timer to 60 seconds for inactive flows.
<Sysname> system-view
[Sysname] ipv6 netstream timeout inactive 60