R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

218
info-center monitor channel
Use info-center monitor channel to configure the monitor channel. The system uses this channel to output
information to the monitor.
Use undo info-center monitor channel to restore the default monitor output channel.
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
Default
The system outputs information to the monitor through channel 1.
Views
System view
Default command level
2: System level
Parameters
channel-number: Specifies a channel by its number in the range of 0 to 9.
channel-name: Specifies a channel by its name, a default name or a self-defined name. For information
about configuring a channel name, see info-center channel name.
Usage guidelines
The info-center monitor channel command takes effect only after the information center enabled with the
info-center enable command.
Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
info-center snmp channel
Use info-center snmp channel to configure the SNMP output channel. The system uses this channel to
output information to the SNMP module.
Use undo info-center snmp channel to restore the default SNMP output channel.
Syntax
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
Default
The system outputs information to the SNMP module through channel 5 (snmpagent).
Views
System view