R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

222
At this time, the system receives log information. It displays the log information first, and then displays
your previous input, which is display current- in this example.
%Apr 29 08:12:44:71 2007 Sysname IFNET/4/LINK UPDOWN:
GigabitEthernet2/0/1: link status is UP
Enter configuration to complete the display current-configuration command, and press the Enter key to
execute the command.
# Enable synchronous information output, and then save the current configuration (enter interactive
information).
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:
At this time, the system receives the log information. It displays the log information first and then displays
[Y/N].
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Y/N]:
Enter Y or N to complete your input.
info-center syslog min-age
Use info-center syslog min-age to configure the minimum time that a syslog message must be kept before
it can be overwritten by new messages.
Use undo info-center syslog channel to restore the default.
Syntax
info-center syslog min-age hours
undo info-center syslog min-age
Default
The minimum age of a syslog message is 0, which indicates that the message can be overwritten by new
messages at any time.
Views
System view
Default command level
2: System level
Parameters
hours: Specifies the minimum age of syslog messages, in the range of 0 to 8760 hours.
Examples
# Set the minimum age of syslog messages to 168 hours.
<Sysname> system-view
[Sysname] info-center syslog min-age 168