R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

42
• A TCP or DLSw operation sets up a connection.
• A UDP jitter or a voice operation sends a specific number of probe packets. The number of probe
packets is configurable with the probe packet-number command.
• An FTP, HTTP, DHCP, or DNS operation uploads or downloads a file, gets a web page, gets an IP
address through DHCP, or translates a domain name to an IP address.
• An ICMP echo or UDP echo operation sends an ICMP echo request or a UDP packet.
• An SNMP operation sends one SNMPv1 packet, one SNMPv2c packet, and one SNMPv3 packet.
If an operation is to perform multiple probes, the system starts the next probe when it receives responses
to packets sent in the first probe, or when the probe timeout time expires.
This command is not available for the voice operation. The voice operation can perform only one probe.
Examples
# Configure the ICMP echo operation to perform 10 probes.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] probe count 10
probe packet-interval
Use probe packet-interval to configure the interval for sending packets in the probe.
Use undo probe packet-interval to restore the default.
Syntax
probe packet-interval packet-interval
undo probe packet-interval
Default
The interval is 20 milliseconds.
Views
UDP jitter operation view, voice operation view
Default command level
2: System level
Parameters
packet-interval: Specifies the interval for sending packets, in the range of 10 to 60000 milliseconds.
Examples
# Configure the UDP jitter operation to send packets at an interval of 100 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] probe packet-interval 100