R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

50
accumulate accumulate-occurrences: Specifies the total number of lost packets in the operation. The
value is in the range of 1 to 15000 for the UDP jitter operation and 1 to 60000 for the voice operation.
action-type: Specifies what action to be triggered. The default action is none.
none: Specifies the action of only displaying results on the terminal display.
trap-only: Specifies the action of displaying results on the terminal display and meanwhile sending
SNMP trap messages to the NMS.
Usage guidelines
You cannot edit a reaction entry. To change the attributes in a reaction entry, use undo reaction to delete
the entry first and then configure a new one.
Examples
# Create reaction entry 1 for monitoring packet loss in the UDP jitter operation. Before the NQA
operation starts, the initial state of the reaction entry is invalid. After the operation, lost packets are
checked. If the total number of lost packets exceeds 100 (included), the state of the reaction entry is set
to over-threshold. Otherwise, the state is set to below-threshold. Once the state of the reaction entry
changes, a trap message is generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element packet-loss
threshold-type accumulate 100 action-type trap-only
reaction checked-element probe-duration
Use reaction checked-element probe-duration to configure a reaction entry for monitoring the operation
duration.
Use undo reaction to delete the specified reaction entry.
Syntax
reaction item-number checked-element probe-duration threshold-type { accumulate
accumulate-occurrences | average | consecutive consecutive-occurrences } threshold-value
upper-threshold lower-threshold [ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entry for monitoring the probe duration is configured.
Views
DHCP operation view, DLSw operation view, DNS operation view, FTP operation view, HTTP operation
view, ICMP echo operation view, SNMP operation view, TCP operation view, UDP echo operation view
Default command level
2: System level
Parameters
item-number: Specifies a reaction entry ID in the range of 1 to 10.
threshold-type: Specifies a threshold type.