R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

58
Examples
# Set the domain name domain1 to be resolved.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type dns
[Sysname-nqa-admin-test-dns] resolve-target domain1
route-option bypass-route
Use route-option bypass-route to enable the routing table bypass function to test the direct connectivity
to the direct destination.
Use undo route-option bypass-route to disable the routing table bypass function.
Syntax
route-option bypass-route
undo route-option bypass-route
Default
The routing table bypass function is disabled.
Views
DLSw operation view, DNS operation view, FTP operation view, HTTP operation view, ICMP echo
operation view, SNMP operation view, TCP operation view, UDP echo operation view, UDP jitter
operation view, voice operation view
Default command level
2: System level
Usage guidelines
When the routing table bypass function is enabled, the routing table is not searched, and the packet is
sent directly to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route
source interface
Use source interface to configure the source interface for ICMP echo request packets. The ICMP echo
request packets take the IP address of the source interface as their source IP address when no source IP
address is specified. The specified source interface must be up. Otherwise, no ICMP echo requests can
be sent out.
Use undo source interface to restore the default.
Syntax
source interface interface-type interface-number