R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

59
undo source interface
Default
No source interface is configured for ICMP echo request packets.
Views
ICMP echo operation view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
Examples
# Specify the primary IP address of interface GigabitEthernet 2/0/1 as the source IP address of ICMP
echo request packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface gigabitethernet 2/0/1
Related commands
source ip
source ip
Use source ip to configure the source IP address of probe packets. The specified source IP address must
be the IP address of a local interface. The local interface must be up. Otherwise, no probe packets can
be sent out.
Use undo source ip to remove the configured source address. The IP address of the interface that sends
a probe packet serves as the source IP address of the probe packet.
Syntax
source ip ip-address
undo source ip
Default
No source IP address is configured for probe packets.
Views
DLSw operation view, FTP operation view, HTTP operation view, ICMP echo operation view, SNMP
operation view, TCP operation view, UDP echo operation view, UDP jitter operation view, voice operation
view
Default command level
2: System level