R3303-HP HSR6800 Routers Network Management and Monitoring Command Reference

88
Parameters
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN to which the NTP server belongs, where
vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the NTP server is on the public
network, do not specify this option.
ip-address: IP address of the NTP server. It must be a unicast address, rather than a broadcast address,
a multicast address or the IP address of the local clock.
server-name: Host name of the NTP server, a string of 1 to 20 characters.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the NTP server,
where keyid is in the range of 1 to 4294967295.
priority: Specifies this NTP server as the first choice under the same condition.
source-interface interface-type interface-number: Specifies the source interface for NTP messages. In an
NTP message the local device sends to the NTP server, the source IP address is the primary IP address of
this interface. interface-type interface-number represents the interface type and number.
version number: Specifies the NTP version. The value range for the number argument is 1 to 4, and the
default is 3.
Usage guidelines
To synchronize the PE to a PE or CE in a VPN, provide vpn-instance vpn-instance-name in your
command.
If you include vpn-instance vpn-instance-name in the undo ntp-service unicast-server command, the
command removes the NTP server with the IP address of ip-address in the specified VPN. If you do not
include vpn-instance vpn-instance-name in this command, the command removes the NTP server with the
IP address of ip-address in the public network.
Examples
# Designate NTP server 10.1.1.1 for the device, and configure the device to run NTP version 3.
<Sysname> system-view
[Sysname] ntp-service unicast-server 10.1.1.1 version 3