R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

138
Ste
p
Command Remarks
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure NetStream
sampling.
ip netstream sampler sampler-name
{ inbound | outbound }
Disabled by default.
You can also execute the command in
system view to enable NetStream
sampling for all interfaces.
4. Enable NetStream.
ip netstream { inbound | outbound }
N/A
Configuring NetStream data export
To allow the NDE to export collected statistics to the NetStream server, configure the source interface out
of which the data is sent and the destination address to which the data is sent.
Configuring NetStream traditional data export
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable NetStream.
ip netstream { inbound | outbound } Disabled by default.
4. Exit to system view.
quit N/A
5. Configure the
destination address and
the destination UDP port
number for the
NetStream traditional
data export.
ip netstream export host ip-address
udp-port [ vpn-instance
vpn-instance-name ]
By default, no destination address or
destination UDP port number is
configured, so the NetStream
traditional data is not exported.
6. Configure the source
interface for NetStream
traditional data export.
ip netstream export source interface
interface-type interface-number
Optional.
By default, the interface where the
NetStream data is sent out (the
interface connects to the NetStream
server) is used as the source interface.
HP recommends that you connect the
network management interface to the
NetStream server and configure it as
the source interface.
7. Limit the data export
rate.
ip netstream export rate rate
Optional.
No limit by default.