R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

151
Ste
p
Command Remarks
3. Enable IPv6 NetStream.
ipv6 netstream { inbound
| outbound }
Disabled by default.
4. Exit to system view.
quit N/A
5. Configure the destination
address and the
destination UDP port
number for the IPv6
NetStream traditional
data export.
ipv6 netstream export
host ip-address udp-port
[ vpn-instance
vpn-instance-name ]
By default, no destination address or destination
UDP port number is configured, so the IPv6
NetStream traditional data is not exported.
6. Configure the source
interface for IPv6
NetStream traditional
data export.
ipv6 netstream export
source interface
interface-type
interface-number
Optional.
By default, the interface where the NetStream
data is sent out (the interface that connects to the
NetStream server) is used as the source interface.
HP recommends that you connect the network
management interface to the NetStream server
and configure it as the source interface.
7. Limit the data export rate.
ipv6 netstream export
rate rate
Optional.
No limit by default.
Configuring IPv6 NetStream aggregation data export
Configurations in IPv6 NetStream aggregation view apply to aggregation data export only, and those in
system view apply to traditional data export. If configurations in IPv6 NetStream aggregation view are
not provided, the configurations in system view apply to the aggregation data export.
To configure IPv6 NetStream aggregation data export:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable IPv6 NetStream.
ipv6 netstream { inbound |
outbound }
Disabled by default.
4. Exit to system view.
quit N/A
5. Set an IPv6 NetStream
aggregation mode and
enter its view.
ipv6 netstream aggregation { as
| bgp-nexthop |
destination-prefix | prefix |
protocol-port | source-prefix }
N/A
6. Configure the
destination address and
destination UDP port
number for the IPv6
NetStream aggregation
data export.
ipv6 netstream export host
ip-address udp-port
[ vpn-instance
vpn-instance-name ]
By default, no destination address or
destination UDP port number is
configured in IPv6 NetStream
aggregation view.
If you expect to export only IPv6
NetStream aggregation data, configure
the destination address in related
aggregation view only.