R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

162
Field Descri
p
tion
Sysname (host name or
host IP address)
• If the system information that is sent to a log host is in the UNICOM format, and
the info-center loghost source command is configured, or the vpn-instance
vpn-instance-name option is provided in the info-center loghost command, the
sysname field is displayed as the IP address of the device that generated the
system information.
• If the system information is in the HP format, the field is displayed as the system
name of the device that generated the system information. You can use the
sysname command to modify the local system name. For more information, see
Fundamentals Command Reference.
%% (vendor ID)
This field indicates that the information was generated by an HP device.
It exists only in system information sent to a log host.
vv (version information)
This field identifies the version of the log, and has a value of 10.
It exists only in system information sent to a log host.
Module
This field specifies source module name. You can execute the info-center source ?
command in system view to view the module list.
Level (severity)
System information is divided into eight severity levels from 0 to 7. See Table 6 for
more information about severity levels. You cannot change the system information
levels generated by modules. However, you can use the info-center source
command to control the output of system information based on severity levels.
Digest
This field briefly describes the content of the system information. It contains a string
of up to 32 characters.
For system information destined to the log host:
• If the string ends with (l), the information is log information.
• If the string ends with (t), the information is trap information.
• If the string ends with (d), the information is debugging information.
Serial Number
This field indicates the serial number of the device that generated the system
information. It is displayed only if the system information sent to the log host is in
the UNICOM format.
source
This optional field identifies the source of the information. It is displayed only if the
system information is sent to a log host in HP format.
It can take one of the following values:
• Slot number of a card.
• IP address of the log sender.
content This field contains the content of the system information.
Table 10 Timestamp precisions and configuration commands
Item Destined to the log host
Destined to the console, monitor
terminal, lo
g
buffer, and lo
g
file
Precision Seconds Milliseconds
Command
used to set the
timestamp
format
info-center timestamp loghost info-center timestamp