R3303-HP HSR6800 Routers Network Management and Monitoring Configuration Guide

168
Ste
p
Command Remarks
5. Configure an output rule for
the log buffer.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "Default output rules of system
informati
on."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debugging information is date
by default.
Outputting system information to the SNMP module
The SNMP module only receives trap information, and discards log and debug information.
To monitor the device running status, trap information is usually sent to the SNMP network management
system (NMS). For this purpose, you must configure output of traps to the SNMP module, and set the trap
sending parameters for the SNMP module. For more information about SNMP, see "Configuring SNMP."
To output system information to the SNMP module:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the information center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See Table 7 for
default channel
names.
4. Configure an output channel
for the SNMP module.
info-center snmp channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
5. Configure an output rule for
the SNMP module.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See "Default output rules of system
informati
on."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debugging information is date
by default.