R3303-HP HSR6800 Routers IP Multicast Command Reference

351
Field Descri
p
tion
Priority RP priority.
HoldTime Timeout time of the RP.
Uptime Length of time since the RP was elected.
Expires Remaining time of the RP.
embedded-rp
Use embedded-rp to enable embedded RP.
Use undo embedded-rp to disable embedded RP or restore the default.
Syntax
embedded-rp [ acl6-number ]
undo embedded-rp [ acl6-number ]
Default
Embedded RP is enabled for IPv6 multicast groups in the default embedded RP address scopes.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
acl6-number: Specifies a basic IPv6 ACL number in the range of 2000 to 2999.
Usage guidelines
The default embedded RP address scopes are FF7x::/12 and FFFx::/12. Here "x" refers to any legal
address scope. For more information about the scope field, see "Multicast overview."
When you use the embedded-rp command without specifying acl6-number, the embedded RP feature is
enabled for all the IPv6 multicast groups in the default embedded RP address scopes. If you specify
acl6-number, the embedded RP feature is enabled for only those IPv6 multicast groups that are within the
default embedded RP address scopes and pass the ACL check.
When you use the undo embedded-rp command without specifying acl6-number, the embedded RP
feature is disabled for all the IPv6 multicast groups. If you specify acl6-number, this command will restore
the default.
Examples
# Enable embedded RP for only those IPv6 multicast groups in the address scope FF7E:140:20::101/64.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff7e:140:20::101 64
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] embedded-rp 2000