R3303-HP HSR6800 Routers MPLS Command Reference

145
mpls te bandwidth change thresholds
Use mpls te bandwidth change thresholds to set the IGP flooding thresholds that apply when bandwidth
resources are increasing and decreasing.
Use undo mpls te bandwidth change thresholds to restore the default.
Syntax
mpls te bandwidth change thresholds { down | up } percent
undo mpls te bandwidth change thresholds { down | up }
Default
The IGP flooding thresholds in both up and down directions are 10.
Views
Interface view
Default command level
2: System level
Parameters
down: Sets the threshold in percentages for IGP to flood when the bandwidth is decreasing. When the
percentage of available bandwidth decrease exceeds the threshold, the change is flooded and the traffic
engineering database (TEDB) is updated.
up: Sets the IGP flooding threshold in percentages that applies when the bandwidth is increasing. When
the percentage of available bandwidth increase exceeds the threshold, the change is flooded and the
TEDB is updated.
percent: IGP flooding threshold in percentages, in the range of 0 to 100.
Examples
# On interface GigabitEthernet 2/1/1 configure IGP to flood when the percentage of available
bandwidth decrease reaches 100%.
<Sysname> system-view
[Sysname] interface giabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] mpls te bandwidth change thresholds down 100
mpls te bfd enable
Use mpls te bfd enable to configure BFD to check the connectivity of the MPLS TE tunnel.
Use undo mpls te bfd enable to disable BFD for the MPLS TE tunnel of a TE tunnel interface.
Syntax
mpls te bfd enable [ discriminator local local-id remote remote-id ]
undo mpls te bfd enable
Default
BFD is not configured for MPLS TE tunnels.
Views
Tunnel interface view