R3303-HP HSR6800 Routers MPLS Command Reference

156
Examples
# Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth
Use mpls te max-link-bandwidth to configure the maximum bandwidth for the link to forward MPLS TE
traffic.
Use undo mpls te max-link-bandwidth to restore the default.
Syntax
mpls te max-link-bandwidth bandwidth-value
undo mpls te max-link-bandwidth
Default
The maximum link bandwidth for MPLS TE traffic is 0.
Views
Interface view
Default command level
2: System level
Parameters
bandwidth-value: Maximum bandwidth of the link, in the range of 1 to 32000000 kbps.
Usage guidelines
The configured maximum link bandwidth is available for only MPLS TE traffic.
Examples
# On interface Serial 2/1/1, set the maximum link bandwidth for MPLS TE traffic to 1158 k b ps .
<Sysname> system-view
[Sysname] interface serial 2/1/1
[Sysname-Serial2/1/1] mpls te max-link-bandwidth 1158
mpls te max-reservable-bandwidth
Use mpls te max-reservable-bandwidth to configure the bandwidth constraints BC 0 and BC 1 in
prestandard DS-TE RDM mode.
Use undo mpls te max-reservable-bandwidth to restore the default.
Syntax
mpls te max-reservable-bandwidth bandwidth-value [ bc1 bc1-bandwidth ]
undo mpls te max-reservable-bandwidth
Default
BC 1 is 0 kbps.