R3303-HP HSR6800 Routers MPLS Command Reference

170
Parameters
Interval: Interval for advertising bandwidth, in the range of 0 to 3600, in seconds.
Usage guidelines
The interval specified by this command is that at which the system will periodically advertise interface
bandwidth if the bandwidth changes are within the specified threshold. To set the interval to 0 means to
disable the bandwidth advertisement function. The minimal valid interval is 30 seconds. If you set the
interval to a value less than 30, the system takes 30 seconds as the interval. If you change the interval
before the current interval elapses, the new setting takes effect. For example, if you set the interval to 30
seconds, and then, within 30 seconds, set the interval to 3600 seconds, the interval of 3600 seconds
takes effect.
Examples
# Set the bandwidth advertising interval to 100 seconds.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te
[Sysname- mpls] mpls te timer link-management periodic-flooding 100
mpls te timer retry
Use mpls te timer retry to configure the interval for re-establishing the tunnel.
Use undo mpls te timer retry to restore the default.
Syntax
mpls te timer retry seconds
undo mpls te timer retry
Default
The interval for re-establishing a tunnel is 2 seconds.
Views
Tunnel interface view
Default command level
2: System level
Parameters
seconds: Interval for re-establishing the tunnel, in the range of 1 to 4294967295 seconds.
Examples
# Set the interval for re-establishing tunnel 0 to 20 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te timer retry 20
Related commands
mpls te retry